|
I can't figure out how to handle the secondary authentication when I do a session command to a fwsm module in a cisco switch. The fwsm has no IP addresses that are acessible, so I can't log into it directly.
Here is what I need to do:
ssh user1@10.10.10.10
user1@10.10.10.10's password:
******
******************* I am OK to this point ******************
switch-1 #session slot 6 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.61 ... Open
************************* NOTICE *************************
This system is intended to be used solely by authorized
users in the course of legitimate corporate business.
Users are monitored to the extent necessary to properly
administer the system, to identify unauthorized users
or users operating beyond their proper authority, and to
investigate improper access or use. By accessing this
system, you are consenting to this monitoring.
************************* NOTICE *************************
User Access Verification
Password:
*******
firewall-1/act> en
Password: *******
firewall-1/act#
sho resource acl-partition
exit
exit
Any help would be appreciated.
Vern
|
(0)
]
